left shadow main shadow main shadow
main shadow
Ld logo
Professional Ligting top_banner
Home top navigation Jobs/Events/News top navigation Catalogs top navigation Manufacturers top navigation Lighting Products top navigation Newsletter Sign-Up top navigation Apps_Blogs top navigation Lighting Feeds
Subpage Top Grad
Indoor Lighting
Left Navigation
Outdoor Lighting
Left Navigation
LED Lighting
Left Navigation
Ballast/Transformers
Left Navigation
Controls
Left Navigation
Lamps/LED
Left Navigation
Emergency/Exit
Left Navigation
Site Sponsors
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Sponsors Images
Industry News
Lightech Introduces Phase Control Dimming LED Drivers Which Dim Down To 0.1%
July 13, 2009

Lightech Electronics  has expanded its product offering to include a new family of phase controlled dimming LED drivers for LED  drive current levels of 350mA, 500mA and 700mA. The product numbers are LED-18-350-120-D, LED-26-500-120-D and LED-36-700-120-D. 

These drivers are intended to be used inside an LED light fixture which is driven directly from the 120V AC power line. They are capable of dimming down to a light level of only 0.1% of full brightness using most of the commonly available dimmers. Either standard TRIAC dimmers or reverse phase control dimmers (trailing edge dimmers) can be used. To get the very best results a list of high performing dimmers is available from Lightech.

Since the full range of control is from 100% down to 0.1%, then this means that the same fixture can be used as both a nightlight or as a regular room illumination light. The 1000X range of control means that three of these drivers can be used with red, green and blue LEDs to make a simple, economical color mixing installation.

The maximum number of LEDs which can be driven is 12, and the minimum number is 3. The most effective dimming  (0.1%) is obtained with 12 LEDs in series. Six LEDs can be dimmed to 0.5% and 3 LEDs can be dimmed down to 1%.

The 120Hz ripple in the output current is typically less than 2%.The output is electrically isolated for safety, conforming to the UL class 2 requirement.

These products have complete protection against output short circuits and open circuits, with fully automatic reset. There is an integral overload voltage surge protector to protect against lightning induced surges on the power line.

They are certified to the FCC class B consumer electromagnetic interference requirement. Each product is available either with side leads (shown) or with bottom feed leads for mounting on a junction box. To order the bottom feed parts add the letters – BF to the part number.

These drivers are approved by Cree for driving Cree LEDs.
In normal use the 18W product has a predicted lifetime in excess of ten years of continuous operation.
 

CONTACT: 

Lightech Electronics

1511 N. Westshore Drive, Suite 255, Tampa FL  33607

Phone: 1-888-544-4832

Email:    [email protected] for USA,  [email protected] for Asia.
 

Trans
Banners
Banners
Banners
Trans Trans
Trans
Main Shadow Right
Indoor Lighting  |   Outdoor Lighting  |   LED Lighting  |   Ballast/Transformers  |   Controls  |   Lamps/LED  |   Emergency/Exit  |   Manufacturers  |   Lighting Products  |   Events  |   Jobs  |   Industry News  |   New Catalogs  |   Site Map  |   Advertising Information
LIGHTDIRECTORY - LightDirectory.com, P.O. Box 1768, Higley AZ, 85236.
Trans